GW Instek LCR-6300 - List of Tables

Table of Contents
10
List of Tables
Table 2-1 Equivalent Circuit ............................................................................ 15
Table 2-2 Display Range ................................................................................... 16
Table 3-1 Front panel description ................................................................... 21
Table 3-2 Rear panel description ..................................................................... 22
Table 4-1 Measurement parameter combinations ......................................... 25
Table 4-2 Monitor parameters .......................................................................... 25
Table 4-3 Measurement and Monitor parameter descriptions ..................... 26
Table 4-4 Impedance range mode ................................................................... 27
Table 4-5 Effective measurement range for the impedance range when in
HOLD state. ...................................................................................... 28
Table 4-6 DCR FUNC effective measurement range for the impedance
range when in HOLD state. ............................................................ 28
Table 4-7 Frequency range and resolution ..................................................... 29
Table 4-8 LCR-6300’s predefined test frequencies that can be selected by
using INCR+/DECR‐ ..................................................................... 30
Table 4-9 LCR-6200’s predefined test frequencies that can be selected by
using INCR+/DECR‐ ..................................................................... 30
Table 4-10 LCR-6100’s predefined test frequencies that can be selected by
using INCR+/DECR‐ ..................................................................... 30
Table 4-11 LCR-6020’s predefined test frequencies that can be selected by
using INCR+/DECR‐ ..................................................................... 30
Table 4-12 LCR-6002’s predefined test frequencies that can be selected by
using INCR+/DECR‐ ..................................................................... 31
Table 4-13 Test voltage/current level that can be selected with
INCR+/DECR‐ ............................................................................... 32
Table 8-1 Handler Interface Signals ~ Output Pins ...................................... 82
Table 8-2 Handler Interface Signals ~ Input Pins ......................................... 83
Table 8-3 Handler Interface Signals ~ Power Pins ....................................... 83
Table 8-4 Timing Definitions ........................................................................... 85
Table 11-1 Multiplier Mnemonics ...................................................................... 97
Table 13-1 Impedance correction factors ....................................................... 137
Table 13-2 Temperature correction factor K
c
................................................ 138
Table 13-3 Correction factor for interpolated open/short trimming K
f
... 138
Table 13-4 Correction factors for the cable length of test leads K
L
............ 138