GW Instek LCR-6300 - DC Bias Voltage [BIAS]; Auto LCZ Function [AUTO LCZ]

LCR-6000 Series User Manual
55
5.1.3 DC Bias Voltage [BIAS]
This function will apply a DC bias voltage onto the DUT
while LCR meter is performing its AC measurement on
the DUT. The settable DC bias voltage range is from -
2.5V ~ 2.5V.
Procedure for setting DC bias voltage
Step 1. Press the [Setup] key.
Step 2. Use the cursor key to select [BIAS] field.
Step 3. Use the soft-keys to select DC bias voltage.
Soft-key
Function
OFF
Turn off the DC bias voltage
2V
2V voltage is applied to the device under
test.
1.5V
1.5V voltage is applied to the device under
test.
-1.5V
-1.5V voltage is applied to the device under
test.
-2V
-2V voltage is applied to the device under
test.
Bias Voltage range
Resolution
0.01V ≦ DC BIAS ≦ 2.50V
0.01V
-2.50V≦ DC BIAS ≦ -0.01V
0.01V
5.1.4 Auto LCZ Function [AUTO LCZ]
Auto LCZ Function can help you to select a proper
measurement parameter.
NOTE
Auto LCZ Function cannot judge complex
components, please do not rely entirely on this
function to measure.