GW Instek LCR-817 - Page 30

LCR-800 Series User Manual
54
RANGE setting:
l Press F1/F2 key to select the white inverted characters “RANGE”.
l PressF3 or F4 key to select up or down value within 1~4 range shown as
Figure 8-10 below.
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
SPEED:SLOW DISPLAY:BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
:1 C.V : OFF
DELAY:00000mS AVG : 1
UP
Press F2 key
to the
RANGE
RANGE
Press F3 .F4
key to select
UP.DOWN
DOWN
Figure 8-10
C.V setting:
l Press F1/F2 key to select the white inverted characters “C.V”.
l Press F3 or F4 key to select ON or OFF shown as Figure 8-11 below. For
further details, please refer to 4-5-5.
Figure 8-11
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
SPEED:SLOW DISPLAY:BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
RANGE:1 : OFF
DELAY:00000mS AVG : 1
ON
Press F2 key
to the OFF
C.V
Press F3 .F4
key to select
ON.OFF
OFF
LCR-800 Series User Manual
55
DELAY setting:
l Press F1/F2 key to select the white inverted characters “DELAY”.
l Key-in Delay value(0~99999ms) through panel keyboard.
l Press ↵ key. Please refer to Figure 8-12 below.
Figure 8-12
AVG setting:
l Press F1/F2 key to select the white inverted characters “AVG”.
l Key-in average value through panel keyboard.
l Press ↵ key shown as Figure 8-13 below. For further details, please refer to
4-5-7.
Figure 8-13
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
SPEED:SLOW DISPLAY:BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
RANGE:1 C.V : OFF
:00000mS AVG : 1
CLR
Press F2 key
to the each
item
DELAY
Press F3 key
to delete the
values input
in error
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
SPEED:SLOW DISPLAY:BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
RANGE:1 C.V : OFF
DELAY:00000mS : 1
CLR
Press F2 key
to the AVG
AVG
Press F3 key
to delete the
values input
in error