PEL-2000 Series User Manual
146
3. Press the FUNC key, Program
(F1) and Active Channel (F2).
Channel 1 (CH01) will be highlighted. Note CH1 has
CH CONT set to External
03/02/09
10 : 30
Configure
Previous
Menu
Save
Recall
Default
Prog
Off
4. Edit the channel using the
Selector knob.
CH 01~08: ON (activate channel) – OFF (not
activated)
5. Press Enter or push the selector
knob to confirm the selection.
6. If needed, repeat steps 4-5 for the
remainder of the channels.
Note
If all channels are Active OFF, a program cannot be
run as there will be no channels active.
Save Program
7. To save press F3.
Recall Default
8. To recall default settings press
F4
Note
If the Default is recalled, all channels will revert to
Active OFF.
To Next Page
Loading...
