PEL-2000 Series User Manual
148
As each sequence or program is completed the screen
will update to display the active sequence/program.
Notice that if a channel has been set up with
Go/NoGo limits, a pass (GO) or fail (NG) will be
displayed on the main display as well as the local load
module display.
The program icon will become orange when a
program has started.
Note
If the Active=OFF for all the channels then “No Active
Channel” will be displayed instead of channel
numbers.
Each active load module will display the output as the
program runs.
14. If Run was configured to manual
in any of the program sequences,
press F2 (Next) to continue the
program sequence, otherwise the
program will continue
automatically.
15. Press F1 (Stop) at any time to
abort the program when it is
running.
To Next Page
Loading...
