To Next PageTo Next Page
Need help?Do you have a question about the GW Instek PSM-6003 and is the answer not in the manual?
General| Output Voltage | 0 - 60V |
|---|---|
| Output Current | 0 - 3A |
| Power Rating | 180W |
| Voltage Resolution | 10 mV |
| Current Resolution | 1 mA |
| Ripple & Noise (CV) | ≤ 1 mVrms |
| Ripple & Noise (CC) | ≤ 3 mArms |
| Display Type | LCD |
| Ripple & Noise | ≤1mVrms (CV), ≤3mArms (CC) |
| Interface | RS232 |
| Load Regulation (CV) | ≤ 0.01% + 3 mV |
| Display | LCD |
| Operating Temperature | 0°C ~ 40°C |
Provides a detailed overview of the PSM-series programmable power supply.
Lists the key characteristics and capabilities of the PSM-series power supply.
Details voltage, current ranges, regulation, ripple, and resolution.
Covers input voltage, interface types, operating conditions, and environmental requirements.
Guides on unpacking, line voltage checks, and suitable operating environments.
Describes the function of controls, indicators, and terminals on the front panel.
Details rear panel terminals, connectors, and display indicators.
Covers initial setup, warm-up, and basic output control procedures.
Explains usage of function keys for setting parameters and protections.
Guides through constant voltage, current, OVP, and OCP operation modes.
Details maximum output settings and test lead usage.
Procedures for replacing fuses and converting line voltage settings.
Recommends measurement techniques and calibration procedures.
Instructions for safely cleaning the instrument.
Illustrates internal functional blocks and their configuration.
