15
Put away the removed power supply in an antistatic bag or the power supply package bag for
future use.
Figure 20 Removing a power supply
Installing/removing a power supply (2)
This section applies to the PSR180-56A, PSR360-56A, PSR560-56D, PSR720-56A, PSR1110-56A,
PSR600-54A-B, PSR920-54A-B, and PSR1600-54A-B power supplies, which use a similar
installation/removal procedure. A PSR360-56A power supply is used as an example.
Installing a power supply
1. Wear an ESD wrist strap. Make sure the strap makes good skin contact and is reliably
grounded.
2. Remove the filler panel, if any, from the target power supply slot.
Put your forefinger into the hole in the filler panel and then pull the filler panel out of the slot
gently.
Keep the removed filler panel secure for future use.
Figure 21 Removing the filler panel from the target power supply slot
3. Unpack the power supply. Make sure the power supply model is as required.
To Next Page
Loading...
