H3C SecPath Series

14
This configuration takes effect only after the URL address filtering function is enabled.
Related commands: firewall http url-filter host enable, display firewall http url-filter host.
Examples
# Configure to permit Web requests using IP addresses for access to websites.
<Sysname> system-view
[Sysname] firewall http url-filter host ip-address permit
firewall http url-filter host load
Syntax
firewall http url-filter host load file-name
undo firewall http url-filter host load
View
System view
Default level
2: System level
Parameters
file-name: Name of the file storing the filtering entries. The name must contain the file path.
Description
Use the firewall http url-filter host load command to configure the firewall to load a specified URL
address filtering file at restart.
Use the undo firewall http url-filter host load command to remove the configuration.
Related commands: display firewall http url-filter host.
Examples
# Specify to load the filtering entries in a file at restart.
<Sysname> system-view
[Sysname] firewall http url-filter host load cfa0:/urlfilter
firewall http url-filter host save
Syntax
firewall http url-filter host save file-name
View
System view
Default level
2: System level
Parameters
file-name: Name of the file for storing the filtering entries. The name must contain the file path.