H3C WA2200 Series - Associating the HTTPS Service with an ACL; Displaying and Maintaining HTTPS

13-4
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the port number of the
HTTPS service
ip https port
port-number
Optional
By default, the port number of the
HTTPS service is 443.
If you execute the ip https port command for multiple times, the last configured port number is used.
Associating the HTTPS Service with an ACL
Associating the HTTPS service with an ACL can filter out requests from some clients to let pass only
clients that pass the ACL filtering.
Follow these steps to associate the HTTPS service with an ACL:
To do… Use the command… Remarks
Enter system view
system-view
—
Associate the HTTPS service with
an ACL
ip https acl
acl-number
Required
Not associated by default.
z The HTTPS service can be associated with a WLAN ACL (with the ACL numbers 100 to 199) and
basic ACL (with the ACL numbers 2000 to 2999), and the two types of ACLs will not overwrite each
other. However, ACLs of the same type will overwrite each other, that is, if you execute the ip https
acl command for multiple times to associate the HTTPS service with the same type of ACLs, the
HTTPS service is only associated with the last specified ACL.
z When the HTTPS service is associated with a WLAN ACL, the HTTPS service uses this ACL to
filter wireless clients only, and does not filter wired clients with this ACL.
z For more information about ACLs, see ACL in the ACL and QoS Configuration Guide.
Displaying and Maintaining HTTPS
To do… Use the command… Remarks
Display information about HTTPS display ip https Available in any view