10-3
To do… Use the command… Remarks
Reboot the AP immediately
reboot
Optional
Available in user view
Follow these steps to reboot a device:
To do… Use the command… Remarks
Enable the scheduled reboot
function and specify a specific
reboot time and date
schedule reboot at
hh:mm
[ date ]
Enable the scheduled reboot
function and specify a reboot waiting
time
schedule reboot delay
{ hh:mm |
mm }
Optional
The scheduled reboot function is
disabled by default.
Execute the command in user
view.
z Before device reboot, use the save command to save the current configurations. For more
information about the save command, see File System in the Fundamentals Command Reference.
z Before device reboot, use the commands of display startup and display boot-loader to check if
the configuration file and boot file for the next boot are configured. For more information about the
display startup command, see File System in the Fundamentals Command Reference. For more
information about the display boot-loader command, see Device Management in the
Fundamentals Command Reference.
z The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the AP will
prompt “REBOOT IN ONE MINUTE” and will reboot in one minute.
z Device reboot may result in the interruption of the ongoing services. Be careful to use these
commands.
z If the current boot file in use fails or does not exist, the AP cannot be rebooted with the reboot
command. In this case, you can re-specify a boot file before rebooting the AP.
z If you are performing file operations when the AP is to be rebooted, the system does not perform
the reboot operation for the sake of security.
Configuring the Scheduled Automatic Execution Function
The scheduled automatic execution function enables the system to automatically execute a specified
command at a specified time in a specified view. This function is used for scheduled system upgrade or
configuration.
Follow these steps to configure the scheduled automatic execution function:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a scheduled task and enter
job view, or enter this view directly
if a task is ready
job
job-name
Required
No scheduled task is created by
default.
To Next Page
Loading...
