5-20
Examples
# Specify the NetBIOS node type as b-node in DHCP address pool 0.
<Sysname> system-view
[Sysname] dhcp server ip-pool 0
[Sysname-dhcp-pool-0] netbios-type b-node
network
Syntax
network network-address [ mask-length | mask mask ]
undo network
View
DHCP address pool view
Default Level
2: System level
Parameters
network-address: IP address range for dynamic allocation. If no mask length and mask is specified, the
natural mask will be used.
mask-length: Mask length, in the range of 1 to 30.
mask mask: Specifies the IP address network mask, in dotted decimal format.
Description
Use the network command to specify the IP address range for dynamic allocation in a DHCP address
pool.
Use the undo network command to remove the specified address range.
No IP address range is specified by default.
Note that you can specify only one network segment for each DHCP global address pool. If you use the
network command repeatedly, the latest configuration will overwrite the previous one.
Related commands: dhcp server ip-pool and display dhcp server tree.
Examples
# Specify 192.168.8.0/24 as the address range for dynamic allocation in DHCP address pool 0.
<Sysname> system-view
[Sysname] dhcp server ip-pool 0
[Sysname-dhcp-pool-0] network 192.168.8.0 mask 255.255.255.0
network ip range
Syntax
network ip range min-address max-address
undo network ip range
View
DHCP address pool view
To Next Page
Loading...
