12-9
Parameters
ipv6-address: IPv6 address whose PMTU information is to be displayed.
all: Displays all PMTU information.
dynamic: Displays all dynamic PMTU information.
static: Displays all static PMTU information.
Description
Use the display ipv6 pathmtu command to display the PMTU information of IPv6 addresses.
Examples
# Display all PMTU information.
<Sysname> display ipv6 pathmtu all
IPv6 Destination Address ZoneID PathMTU Age Type
fe80::12 0 1300 40 Dynamic
2222::3 0 1280 - Static
Table 12-5 display ipv6 pathmtu command output description
Field Description
IPv6 Destination Address Destination IPv6 address
ZoneID ID of address zone, currently invalid
PathMTU PMTU of an IPv6 address
Age Time for a PMTU to live. For a static PMTU, a hyphen “-“ is displayed.
Type Indicates the PMTU is dynamically negotiated or statically configured.
display ipv6 socket
Syntax
display ipv6 socket [ socktype socket-type ] [ task-id socket-id ]
View
Any view
Default Level
1: Monitor level
Parameters
socktype socket-type: Displays the socket information of this type. The socket type is in the range of 1
to 3. The value “1” represents a TCP socket, “2” a UDP socket, and “3” a raw IP socket.
task-id: Displays the socket information of the task. The task ID is in the range 1 to 150..
socket-id: Displays the information of the socket. The socket ID is in the range 0 to 3072.
Description
Use the display ipv6 socket command to display socket information.
With no parameter specified, this command displays the information about all the sockets; with only the
socket type specified, the command displays the information about sockets of the specified type; with
To Next Page
Loading...
Need help?
General
