1-1
1 Preparing for installation
Safety recommendations
professional technical personnel can install and remove the AP and its
accessories. You must
read all safety instructions carefully before working with the AP.
To avoid possible bodily injury and equipment damage, read the following safety recommendations
before installing the AP. Note that the recommendations do not cover every possible hazardous
condition.
To avoid bodily injury and device damage, take adequate safety measures.
Place the AP in a dry and flat location and take anti-slip measures.
Keep the AP clean and dust-free.
Do not place the AP in a moist area and avoid liquid intrusion.
Keep the AP and installation tools away from walkways.
Site preparation
Before installing the AP, examine the installation site and make sure the AP will operate in a
favorable environment. Make sure the temperature and humidity at the installation site meet the
requirements in Table 1-1.
Table 1-1 Temperature and humidity requirements
Operating temperature
-10°C to 55°C (32°F to 113°F)
Storage temperature
–40°C to +70°C (–40°F to +158°F)
Operating humidity
5% RH to 95% RH, noncondensing
Installation accessories
Figure 1-1 Accessories provided with the AP
To Next Page
Loading...
