Need help?Do you have a question about the Hach 5500sc PO4 3-LR and is the answer not in the manual?
General| Power Supply | 100 - 240 VAC, 50/60 Hz |
|---|---|
| Light Source | LED |
| Wavelength | 880 nm |
| Operating Temperature | 5 to 40 °C |
| Sample Temperature | 5 to 40 °C |
| Power Requirements | 100 - 240 VAC, 50/60 Hz |
| Resolution | 0.01 mg/L |
| Detector | Photodiode |
| Detection Limit | 0.05 mg/L PO4 |
| Calibration | Automatic |
| Display | LCD |
| Accuracy | ±0.05 mg/L or ±5% of reading |
| Cycle Time | 5 to 120 minutes |
| Operating Humidity | 5 to 85% relative humidity, non-condensing |
| Power Consumption | 30 VA |
| Outputs | 4-20 mA |
| Enclosure Rating | IP65 |
| Response Time | 5 to 120 minutes |
| Battery Life | Not applicable |
Explains the function of each key on the analyzer's keypad.
Describes the elements shown on the measurement and system status screens.
Step-by-step instructions for powering on the analyzer.
Guides through initial configuration settings after powering on.
Setting up variables, parameters, units, and formulas for analysis.
Configuring 4-20 mA setup, relay setup, and error hold mode.
Selects the sensor referring to the variable X.
Initiates a manual calibration process.
Schedules automatic calibration for the analyzer.
To Next Page