EasyManua.ls Logo

Hach 900 MAX - Page 48

Hach 900 MAX
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 46
Basic Programming Setup
8990startup.fm
Section 3
If NO is selected:
a. Select Samples per Bottle or Bottles per Sample.
Example 1: Samples Per Bottle
Bottles— 8
Sample Collection; Time-Proportional; Sampling Interval—30 min.
Sample Distribution; Deliver Each Sample to All Bottles?— No
Samples Per Bottle— Yes
Number of Samples Per Bottle— 3
Sample Volume—100 mL
Every 30 minutes a sample is initiated. A 100 mL sample is drawn into
bottle #1, 30 minutes later a second sample is drawn into bottle #1, 30
minutes later a third sample is drawn into bottles #1. Thirty minutes later
the distributor arm advances to bottle #2 and a 100 mL sample is drawn
into bottle #2. The sequence continues until all bottles are filled. Each
bottle receives three samples before the distributor moves to the next
bottle.
Example 2: Bottles Per Sample
Bottles— 4
Sample Collection; Timed Proportional; Sampling Interval— 30 min.
Sample Distribution; Deliver Each Sample to All Bottles?— No
Bottles Per Sample— Yes
Number of Bottles Per Sample— 2
Sample Volume— 1000 mL
Note: A high pressure air purge is
automatically applied to the intake
tube between each sample
intake cycle.
Every 30 minutes a sample cycle is initiated. A 1000 mL sample is drawn
into the first bottle. The distributor arm immediately advances to bottle #2
and a 1000 mL sample is drawn into the second bottle. Thirty minutes
later, the distributor arm advances to bottle #3, and a 1000 mL sample is
taken. The distributor arm immediately advances to bottle #4 and a 1000
mL sample is drawn into the fourth bottle. The pattern continues each
sample cycle with each set of two bottles receiving a sample each time.
b. Press
ACCEPT to continue with Liquid Sensor setup.
If
YES is selected:
Each time a sample is taken it is consecutively placed in all bottles. This
allows for split samples.
a. Select Stop After Last Sample or Run Continuously.
11:00 AM 21 - APR - 01 SAMPLE DISTRIBUTION
ACCEPT
RUN MODE:
CHANGE
CHOICE
RUN CONTINUOUSLY
BACKUP
CHOICES: CONTINUOUS, STOP AFTER LAST

Table of Contents

Related product manuals