1. Push CALIBRATION or push MENU and select Calibration.
2. Select the sensor to calibrate.
3. Obey the screen prompts to complete the procedure. Refer to the sensor documentation.
Calibrate the cabinet temperature—AWRS sampler
Refer to the service manual available on the manufacturer's website for the calibration procedure.
Start or stop the program
Start the sampling program to collect samples. Temporarily stop the sampling program to remove
samples, do manual operation or do a calibration. Stop the sampling program to change the
sampling program, the data log settings or the channel alarms.
Note: When data logging is configured, data logging is done even when the sampling program is temporarily
stopped.
1. Push RUN/HALT.
2. Select an option.
Option Description
Start Program Starts the sampling program.
Note: The sampling program may not start immediately. Refer to Select when the
sampling program starts on page 19.
Halt Program Stops the sampling program temporarily. The status changes to Program Halted.
Resume Starts the sampling program from the point at which it was stopped.
Start From Beginning Starts the sampling program from the beginning.
End Program Stops the sampling program. The status changes to Program Complete.
Show data and alarms
Show the program status
1. Push STATUS or select Diagnostics>Status from the main menu.
2. If two sampling programs are in operation, select one of the sampling programs. The status of the
sampling program shows. In addition, the sample status, data log status, alarm status and
hardware status shows.
Status Description
Program Running The sampling program is in operation.
24 English
To Next Page
Loading...
Need help?
General
