Hach DRB 200 Instrument Manual

15
Section 2 Instrument Use
2.1 Starting-up
DANGER
The ventilation slits
in the lid must not be
covered, or
overheating may
occur.
1. Place the instrument on a stable, level, heat-resistant
surface.
2. Plug in the power cord into a power socket (100–230 V
+5%/–15%, 50/60 Hz).
3. Switch on the instrument by switching the power switch
(
Figure 4).
4. After initialization, the instrument will beep once, indicating
that it is ready for operation. The display always shows the
most recent setting of the temperature programs after
initialization.
Figure 4 Back View of the DRB 200 Digital Reactor Block
2.1.1 Setting the Language
The default factory setting is English. To change the default
setting:
1. Hold down the left key while switching on the instrument.
Initializing
VX.X
1. Power Switch 2. Power Plug 3. Nameplate

Hach DRB 200 Specifications

General

Temperature Stability	±0.2 °C
Block Material	Aluminum
Display	Digital
Power Supply	100-240 V AC, 50/60 Hz
Block Capacity	16 mm diameter tubes
Number of Holes	Varies depending on block type (e.g., 40, 15)
Hole Diameter	16 mm
Temperature Range	37 - 165 °C (98.6 - 329 °F)