What to do if Hach LZV902 displays 'Error copying from USB memory stick'?
If the Hach Measuring Instruments displays 'Error copying from USB memory stick', it means there was an error during the update. Start the procedure again or contact technical support.
What to do if Hach Measuring Instruments says 'Update file is faulty'?
If the Hach Measuring Instruments indicates that the update file is faulty, it means there was an error during the update. Save the update file again and repeat the procedure.
What to do if Hach Measuring Instruments displays 'Remote server cannot be reached'?
If the Hach Measuring Instruments displays 'Remote server cannot be reached', it indicates an error during network setup. Make sure that the instrument is connected to the network, as the fixed address of the DR 6000 may not be accepted.
What to do if Hach LZV902 displays 'Remote server unreachable!'?
If the Hach Measuring Instruments displays 'Remote server unreachable!', it means that the fixed address of the DR 6000 is not accepted, or the server name entered is incorrect. Switch to "Automatic" or enter the correct server name.
What to do if Hach Measuring Instruments displays 'Error in FTP connection'?
If the Hach Measuring Instruments displays 'Error in FTP connection', it indicates an FTP error. Make sure that the instrument is connected to the network.
General| Accuracy | ±5% of reading or ±5 mg/L (ppm), whichever is greater |
|---|---|
| Operating Temperature | 0 to 60 °C (32 to 140 °F) |
| Range | 0 - 4000 mg/L (ppm) |
| Output | 4-20 mA, RS-485 Modbus |
| Measurement Range | 0 - 4000 mg/L (ppm) |
| Wetted Materials | 316 stainless steel |
To Next Page