Need help?Do you have a question about the Hach LDO101 and is the answer not in the manual?
General| Parameter Measured | Dissolved Oxygen (DO) |
|---|---|
| Measurement Range | 0 to 20 mg/L |
| Resolution | 0.01 mg/L |
| Accuracy | ± 0.1 mg/L |
| Operating Temperature | 0 to 50 °C |
| IP Rating | IP68 |
| Type | Luminescent Dissolved Oxygen Sensor |
| Technology | Luminescent |
| Response Time | 90% in less than 30 seconds |
| Output | Digital (Modbus RS485) |
| Sensor Type | Optical |
| Cable Length | 10 m |
Defines the intended applications and user scope for the Intellical probes.
Explains hazard symbols (DANGER, WARNING, CAUTION) and their meanings for user safety.
Instructs users to read all labels and tags attached to the instrument for safety and potential hazards.
Details specific hazards related to chemical exposure and required personal protective equipment.
Provides essential tips and considerations before performing probe calibration for best results.
Details the step-by-step process for performing a 100% dissolved oxygen calibration.
Offers important considerations and best practices before taking sample measurements.
Describes the practical steps for conducting dissolved oxygen sample measurements.
Explains how to properly clean the LDO probe, including the sensor cap and lens, using appropriate solutions.
Explains how to remove and install the protective shroud on the probe for calibration and use.
To Next Page