User interface and navigation
Display description
Figure 4 shows the measurements, calibration standard information and indicator icons
shown on the display. Table 1 gives descriptions of the icons.
Figure 4 Display overview
1 Calibration icon 5 Battery icon 9 Temperature
2 Lock icon 6 Parameter value 10 Custom standard (C1, C2)
4
3 Sensor? icon 7 Calibration standard(s) measured for
last calibration (low, medium, high)
2
4 Parameter 8 Calibration standard(s) expected
3
Table 1 Display icons
Icon Description
Shows the battery power level. Flashes when the battery power is less than 10%.
Shows when the lock feature is on. When the lock feature is on, the parameter value on the display does not
change. Push to set the lock feature to on or off.
Sensor? Refer to Troubleshooting on page 10.
Shows when the tester is in calibration mode or when a calibration is due. If "?" shows next to the calibration icon,
the last calibration was not successful. When the ACAL setting is set to Yes (default), "?" shows next to the
calibration icon when a calibration is due.
Keypad description
Figure 5 and Figure 6 show the Pocket Pro and Pocket Pro+ keypads. Table 2 gives the
key descriptions.
2
Shows after auto calibration
3
Shows during auto calibration
4
Shows during custom calibration.
6
To Next Page
Loading...
