Message Solution
The standard is not stable. Use the correct calibration standards. Invert the standard until no bubbles or large
particles show.
The standard value is out of
the measurement range.
Use the correct calibration standards. Invert the standards. Make sure to measure
the standards in ascending order.
The standard value is too
low.
The wrong calibration standard is in the vial compartment. Make sure that the
standard has not expired.
Put the correct calibration standard in the vial compartment. Make sure to invert
the standard.
The standard value is too
high.
The wrong calibration standard is in the vial compartment. Make sure that the
standard has not expired.
Put the correct calibration standard in the vial compartment.
Verification failed. Examine the verification standard. Calibrate the instrument. Refer to Calibrate the
turbidimeter with StablCal Standards on page 13.
If verification is not successful after calibration, contact technical support.
Instrument update
Copy from USB Memory
failed
Remove large files from the USB flash drive that use too much space. Start the
instrument update procedure again.
Remove the instrument update files from the USB flash drive. Save the instrument
update files again to the USB flash drive.
Connect the USB flash drive to the instrument. Start the instrument update
procedure again.
Instrument update file is
missing
Remove the instrument update files from the USB flash drive. Save the instrument
update files again to the USB flash drive.
Connect the USB flash drive to the instrument. Start the instrument update
procedure again.
Instrument update file is
corrupt
Not enough memory to
update the instrument
Contact technical support.
USB memory is not
connected.
Connect a USB flash drive to the instrument. Make sure that the file system
"FAT32" is installed on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Connect
the USB flash drive. Start the instrument update procedure again.
Read/Write to USB flash drive
Cannot write to USB
memory
Connect a USB flash drive to the instrument. Make sure that the file system
"FAT32" is installed on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Look for
remaining space on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Connect
the USB flash drive to the instrument.
Cannot read from USB
memory
Restore backup
No instrument backup is
available.
Connect a USB flash drive to the instrument. Make sure that the file system
"FAT32" is installed on the USB flash drive.
Set the power to off, wait 20 seconds and then set the power to on again. Connect
the USB flash drive. Start the instrument update procedure again.
Not able to restore the
backup
Security
Invalid password Enter the correct password. If the password is lost, contact technical support.
22 English
To Next Page
Loading...
