Figure 3 Installation overview with no accessories
1 Service bracket 5 Sample inlet
2 Process head 6 Sample outlet
3 SC controller 7 TU5300 sc or TU5400 sc
4 Flow regulator
Wall mount
Install the instrument on a wall in a vertical position. Install the instrument so that it is level.
Install with the wall mount bracket
Refer to the illustrated steps that follow to install the instrument on a wall with the wall mount bracket.
The mounting hardware to install the wall mount bracket on a wall is supplied by the user.
If a 1720D, 1720E, or FT660 instrument is replaced, remove the instrument from the wall. Then do
steps 2 to 4 of the illustrated steps that follow to install the instrument on the existing hardware.
Note: When the accessories are used, the installation location of the tubing clips is different. Refer to the
documentation supplied with the accessories for tubing clip installation.
English
11
To Next Page
Loading...
