Hafco bd-325 - Plant Safety Program Overview; Hazard Identification and Control Framework; Risk Control Strategies for Hazards

Manager:
Ensure correct spindle direction when drilling..
Wear hearing protection as required.
For Radial Arm Drills ensure that arm is locked before drilling.
Revised Date:
www.machineryhouse.com.au
www.machineryhouse.co.nz
12th March 2012
Make sure all guards are secured shut when machine is on.
Plant Safety Program to be read in conjunction with manufactures instructions
HIGH TEMPERATURE
MEDIUM
Wear appropriate protective clothing to prevent hot swarf.
Machine should be installed & checked by a Licensed Electrician.
Eliminate, avoid loose clothing / Long hair etc.
Isolate power to machine when changing speeds or maintenance is being carried out.
Wear safety glasses.
Do not adjust or clean until the machine has fully stopped.
MEDIUM
Isolate power to machine prior to any checks or maintenance being carried out.
SHEARING
HIGH
Risk Control Strategies
(Recommended for Purchase / Buyer / User)
Secure & support work material on drill table.
A
C
OTHER HAZARDS, NOISE.
F
ENTANGLEMENT
CUTTING, STABBING,
O
M
H
ELECTRICAL
PLANT SAFETY PROGRAM
No.
Hazard
Identification
Developed in Co-operation Between A.W.I.S.A and Australia Chamber of Manufactures
This program is based upon the Safe Work Australia, Code of Practice - Managing Risks of Plant in the Workplace ( WHSA 2011 No10 )
Safety officer:
LOW
NEW MACHINERY HAZARD IDENTIFICATION, ASSESSMENT & CONTROL
STRIKING
MEDIUM
Ensure workpieces are tightly secured on machine.
Item
B
Authorised and signed by:
Hazard
Drilling Machine
D
Assessment
LOW
CRUSHING
All electrical enclosures should only be opened with a tool that is not to be kept with the machine.
Never clean or dust machine when power is on.
LOW
PUNCTURING.
MEDIUM
Page 36
Instructions Manual for BD-325 (D590)
19/11/2015