Digitech ENU rev. Feb 2011
©Haglöf Sweden®AB Mantax Digitech - 12 -
The IR reading can be stopped by pressing ESC on the Digitech caliper (L + R buttons).
LINE
In the LINE Menu, captured trees are transferred directly via Radio or IR without storage in the internal
memory. Register tree species and diameters in the same way as in LOCAL menu. Radio or IR is set under menu
SET. Data is transferred as 4 signs, where the first sign represents the species number ’1’..’8’. The other three
signs represent the diameter in mm (or inches +10) and finishes with CR and LF (Carrige Return, Line Feed). The
receiving serial port should be set to 1200,8,N,1. Radio-receiver DigiRadio V1.6 or IR-receiver IR6 can be used
as receiving module.
Ex. 1224 [CR]+[LF]
1=species and 224 is the diameter in mms
CR=carrige return character, LF=Line feed character.
Note: The caliper Id can be set in the Digitech® menu Set. If the Id is 1, 2, 3, 4, 5 or 6, an extra digit is added
after the diameter digits. This makes it possible for a receiving unit (handheld computer) to separate caliper
data if more than one caliper unit is operating in the field transferring online measuring results.
Ex. 12245 [CR]+[LF] when Caliper Id is set to 5.Caliper Id 0 is the default setting, no Id after diameter
character.
To Next Page
Loading...
Need help?
General
