Use
Notice
▶ The appliance is preset to the recommended temperature of 5°C (refrigerator) and -
18°C (freezer). Under normal ambient condition you need not to set a temperature.
▶ When the appliance is switched on after disconnection from the main power supply, it
may take up to 12 hours for the correct temperatures to be reached.
Notice
The control panel is automatically blocked against activation if 30 seconds no button is
pressed. For any settings the control panel must be unlocked.
Select the working mode
You may need to select one of the following two ways to set the appliance:
1) Fuzzy mode
Under fuzzy mode, the appliance can automatically adjust the temperature setting ac-
cording to the ambient temperature and temperature change in the appliance. If you do
not have any special requirements, we recommend that you use fuzzy mode (refer to
FUZZY MODE).
2) Manual adjusting mode:
If you want to manually adjust the temperature of the appliance in order to store a par-
ticular food, you can set the temperature via a temperature adjusting button (refer to
ADJUST THE TEMPERATURE).
Empty the appliance before switching o. To switch o the appliance,pull the power cord
out o the power socket.
The indoor temperatures are inuenced by the follow-
ing factors:
▶ Ambient temperature
▶ Frequency of door opening
▶ Amount of stored foods
▶ Installation of the appliance
12 13
Lock/unlock panel
▶ Touch button “G” for 3 seconds to block all panel
elements against activation. The related indicator
“g” is now displayed.
▶ For unlocking press again the button.
Lock
Hold 3 Sec.
Switch on /o the appliance
The appliance is in operation as soon as it is connected to the power supply.
When the appliance is powered on for the rst time, indicator “c2” is shining on the display
until the temperature reaches -5°C or after 1 hour working. The temperatures displayed in
“a2”, “b” and “c2” will shown the actual temperatures in the compartment.
Standby-mode
The display screen turns o automatically 30 seconds after pressing a key. The display will
be automatically locked. It lights up automatically when pressing any key or opening the
door (Alarm does not light up the display screen).
Adjust the temperature for fridge
1. Unlock the panel if it is locked.
2. Press button „A“ (Fridge) for select the fridge
compartment. Indicator „a2“ is ashing.
3. Press button “A” to set the refrigerator tempera-
ture.
The temperature increases in sequences of 1°C
from a minimum of 2°C to a maximum of 8°C,
switching to 2°C again when pressing further.
The optimum temperature in the refrigerator is
5 ° C. Colder temperatures mean unnecessary
energy consumption.
4. Press any key except „A“ to conrm, or the setting
conrms automatically after 5 seconds. Indicator
„a2“ stops ashing
Door/drawer opening alarm
When the refrigerator door or the freezer drawer is
opened for more than 3 minutes, the door/drawer
opening alarm will sound. The alarm can be silenced by
either closing the door/drawer or touching the control
panel. If the door/drawer is left open for more than 7
minutes, the light inside the refrigerator/under the re-
frigerator door and control panel illumination will auto-
matically switch o.
Adjust the temperature
Sensor keys
The buttons on the control panel are sensor keys, which already respond when lightly
touched with the nger.
To Next Page
Loading...
