WARNING!
Free Standing Installation
Install the appliance on solid
ground. Adjust accurately all feet
Only with a correct level the
appliance door closes and seals
correctly.
Installation under Worktop
5. The dimensions of the recess should
at least agree with the dimensions in
.
7. Put
6.
After installation, the minmum gap
between the side planel and the
cupboard is 1mm, and the minmum
gap between the rear and the cupboard
is 10mm. The top gap is controlled
by adjusting the feet.
the appliance adjacent to the
slot. Make sure that all connections
(water, drain water, power) are neatly
positioned and connected.
1.
2.
4.
Install the appliance carefully into
the recess.
3.
Stick the water-proof sticker on the
bottom of the kitchen board
WARNING!
If used as free standing appli-
ance again, the worktop must be
remounted.
598
min580
570
820
min820
min600
Any installation may be carried out only by a qualitied technician
refer to section SAFETY.
5
Installation
NZ AU
Optional:Remove the work top of
the appliance.
Adjust accurately all feet to get a
firm level position.
To Next Page
Loading...
Need help?
General
