- 33 -
1.2.4 Set indoor communication address, central control address and
slave unit address(model, No., position) ,and fill all these information in the
“additional refrigerant charging list” on front plate of the master unit.
1.2.4.1 Setting method of communication address between indoor and
outdoor
No.
Setting
mode
Setting method Remark
1
unit No.
setting
automatically
Dip switch SW02 and SW03 on indoor
PCB are all at “off” (down), that also is the
setting state when out of factory.
setting
state
when
out of
factory
2
unit No.
setting by
hand
1. “1” and “2” of SW03 at “ON” ( up)
2. details about unit No. and dipswitch
state please refer to the following
table
setting
on site
Part 2
To Next Page
Loading...
