9
Charging your HALO
The device arrives from the factory
partially charged (approximately
60% of full charge). While you
can use the device immediately,
it is recommended that you fully
charge your new device.
Using the Mains to USB power
adaptor supplied, plug one end
of the USB charging cable into the
micro USB port on the HALO Digital
Goniometer and the other end into
the USB power adaptor.
Plug the power adaptor into a
mains (240V) wall socket. The
device will be fully charged in less
than two hours.
Alternatively, you can plug the
HALO Digital Goniometer into a
USB port on your computer to
charge it.
To Next Page
Loading...