Hammond X-5 - Page 11

Step Test & Test Point
Depress Tab,
or
Extend
Tone Bar
Play Keys Adjust
Oscilloscope
or Other Ind
Fig-
(0
Lower Man. Tone
Bar
8'
Tone/Bar
4'
2-2/3'
2'
1-3/5'
1-1/3'
1'
2.9v rms.
2.3v rms.
2.0v rms.
2.2v rms.
2.2v rms.
2.1v rms.
2.4v rms.
5 (a)
(b)
Pedal
I Pedal Decay Time
Across Speaker
II Pedal Level
Across t>peaKer
Pedal Tab.
8'
&
String Bass I &
II Tab. to "ON"
String
Bass Tab.
to "OFF".
String
Bass Tab.
[ to "ON".
String Bass Tab.
II to "ON"
Pedal Tone Bar
Pedal
Tab. to
8'
Pedal
Tone Bar
to 8
Pedal Tab. to
8'
Mute Tab. to
"ON"
Pedal
Pedal Key C of
High Note
Pedal Key
C
of
nign Note
Pedal Key
G
Pedal Key C of
Low Note
Pedal Key
C
of
High Note
Pot. VR2 on
SB-5{B) Bd.
Pot. VR1 on
SB-5( B)
1
.5
sec.
1 50 msec.
±
15 msec.
400 msec.
±
40 msec.
800 msec.
±
80 msec.
3.4v rms.
4.5v
± 0.5v rms.
5.4v
+
0.5v rms.
2.3v±0.5v rms.
2
6 [a|
Across Speaker
Noise Level
Full Tibias Tab.
to "ON".
Mid.
Key
C
on
Up.
Man.
Level is at ~20dB
~-24dB
when
Exp. Pedal MAX
to MIN.
(Level
is
OdB at
Exp.
Pedal MAX)
7
(ft)
Across Speaker AIITab.s to ON
(Except Reverb
Tab. & Mute Tab.)
All Tone Bars to 8
All Tab.s to OFF
All
Tone Bars to
(OFF), and
Percussion Tab.s
to ON
Mid.
Key
C
on
Up.
Man.
& Low. Man.
5 mv rms. MAX.
10 mv rms. MAX.
No
noise occurs.
•NOTE: During Test Procedure The Following Must Be Maintained Unless
Otherwise
Stated:
a.
All Control Knobs and Expression Pedal ai Maximum.
b. All Tab.s
and All Tone Bars in the Off Position.