What causes a Brake Lamp Short on my Handicare Scooter?
A Brake Lamp Short on your Handicare Scooter indicates that the control system has detected a short in the Brake Lamp Circuit. Check the brake lamps, cables, and connections to the control system. If the error persists after these checks, the ISM may be defective.
What does 'System Error' mean on my Handicare Wheelchair and how can I fix it?
A 'System Error' indicates a fault that cannot be attributed to a specific module. Check all cables and connections. Cycle the power. If the error persists and the system contains 3rd party Modules: Disconnect all the none PGDT modules and cycle the power. If this has cleared the trip: Connect each 3rd party module in turn, cycling the power each time. If the trip reappears after one of the power cycles then the last module to have been added to the system must be defective. If the error persists, the PGDT control system may be defective.
What does it mean when the service indicator flashes twice and the ON/OFF light flashes three times on a Handicare Wheelchair?
This indicates a battery fault or a defective M1 motor. Check the batteries and cabling, charge or replace the batteries, and check the motor connections and cabling. If the issue persists, the M1 motor may need to be replaced.
What to do if the ON/OFF light flashes 5 times on Handicare Scooter?
If the ON/OFF light flashes 5 times on your Handicare Scooter, it indicates that the m1 parking brake connection is faulty or loose, or the m1 parking brake is defective. Correct the connection if it's faulty or loose, or replace the drive motor if the parking brake is defective.
What does it mean if the ON/OFF light flashes once on my Handicare Scooter?
If the ON/OFF light flashes once on your Handicare Scooter, it indicates a DX module fault. Replace one or more modules. The 'on/off' LED indicates the condition of the entire system.
What does 'Left Lamp Short' mean on my Handicare Puma 20 Wheelchair and what should I do?
A 'Left Lamp Short' means the control system has detected a short in either of the Lamp Circuits. Check the lamps, cables, and connections to the control system. If the error persists, the ISM may be defective.
What does 'DIME Error' mean on my Handicare Puma 20 and how can I fix it?
A 'DIME Error' indicates an identification conflict between two modules in the system. If a new module has been introduced: Disconnect the new module and cycle the power. If no error is present, connect the new module to the system and cycle the power. If the error reappears, the new module is the cause. If there have been no additions: Disconnect one module at a time and cycle the power.
Why is the ON/OFF light flashing four times on my Handicare Scooter?
If the ON/OFF light flashes four times on your Handicare Scooter, it could be due to a faulty connection or a defective m2 motor. Check the motor connections and cabling. If the connections are fine, the m2 motor may need to be replaced.
How do I fix a Joystick Calibration Error on my Handicare Scooter?
A Joystick Calibration Error on your Handicare Scooter means the joystick calibration process was unsuccessful. Enter OBP and attempt calibration. If the error persists, the Joystick Module may be defective.
How to fix Joystick Calibration Error on Handicare Mobility Aid?
If your Handicare Mobility Aid displays 'Joystick Calibration Error', it means the Joystick Calibration process has not been successful. Enter OBP and attempt calibration. If the error persists, the Joystick Module may be defective.
Advises on avoiding contact with hot motors and parts exposed to direct sunlight to prevent burns.
Warns users to avoid contact with moving components like motors and wheels to prevent injury.
Provides guidance on operating the wheelchair in various environments and outlines safety precautions.
Lists essential checks to perform before driving the wheelchair to ensure safe operation.
Explains safe procedures for transferring into and out of the wheelchair.
Instructions on operating the controller and joystick, handling curves, braking, emergency stops, and slope operation.
Crucial safety information and requirements for transporting the wheelchair in a vehicle.
Explains the correct procedure for fastening the seat belt to ensure occupant safety during transport.
Details the recommended schedule for daily, weekly, monthly, and annual maintenance tasks.
Covers battery types, charging procedures, and essential maintenance for optimal performance.
Lists common checks to perform if the wheelchair is not functioning correctly.
General| Type | Power Wheelchair |
|---|---|
| Foldable | No |
| Footrests | Yes |
| Seat Width | 40-48 cm |
| Seat Depth | 40-48 cm |
| Backrest Height | 40-50 cm |
To Next Page
