20
Step 8
Carefully slide the wing panels together. Apply enough
pressure to firmly seat the two wing panels together,
causing any excess epoxy to ooze out from between
the panels. Use rubbing alcohol and a paper towel
to remove the excess epoxy. Check to make sure
there are no visible gaps between the panels.
Step 9
Use masking tape to securely hold the wing
panels together. Allow the epoxy to fully cure
before continuing to the next section.
Step 10
Once the epoxy has fully cured, use a sealing iron to apply
the trim to the joint between the outer panel and center
panel. Position the wing so the tip panel is up. The weight
should fall to the center where it can be retrieved from the
opening for the retract servo. Pull the servo lead through.
Step 11
Repeat Steps 1 through 10 for the remaining wing panel.
Section 3: Joining the Wing Panels
To Next Page
Loading...
