4. Operation
4.4 Loading tubes
• Only use tubes provided or approved by Hanil Scientific Inc.
• Always use the same type of tube.
• Tubes should be loaded symmetrically.
• Do not exceed the maximum rated speed of the tube.
• Same volume of sample should be put on tubes.
• Check symmetric loading by balncing tubes with scales.
① Check the maximum load for each tube.
② Put tubes into rotor holes.
③ Tubes located opposite each other must be the same type and contain the same quantity.
Correct arrangement
Wrong arrangement
A/S : +82-2-3452-8966 / techsupport@ihanil.com 12
To Next Page
Loading...
