Hanil FLETA 4 - Starting, Stopping, and Short Spin

2. Press the Start( ) button more than 2sec.
4. Operation
4.8 Setting Accelation/Deceleration rate
1.Press the Setup/Enter ( ) button.
▶Accel setting mode : accel flashes on display
▶Decel setting mode: decel flashes on display
2. Press the Left( ) or Right( ) button to select Aceel / Decel mode.
3. Press the up( ) or down ( ) buttons until the desired Accel/Decel step is displayed.
4. Press the Setup/Enter ( ) button.
4.9 Start/Stop/Short Spin
Starting a centrifugation
1. Check the all parameters are correct and the lid is closed.
▶If the lid is not closed, it will not start.
Stopping a centrifugation
1. Press the Stop ( ) button to stop a centrifugation.
2. Press the Start ( ) button.
A/S : +82-2-3452-8966 / techsupport@ihanil.com 14
Short spin
1. Set the desired speed.[Refer to 4.5 Setting RPM/RCF]