5. Maintenance
5.1 Care instructions
• The following procedures should be performed regulary.
①Regularly inspect the rotor chamber for check the motor shaft is nomal.
②Rotate the shaft with your hand to make sure it turns smoothly
③Use the stopwatch to check that the time setting is correct
④If you find any damages, do not use the device. Contact Hanil Scientific Inc.
5.2 Cleaning
• Before cleaning the centrifuge, be sure to switch off the device and
disconnect the power cord.
• Oustside of the device
①Clean the outside of the device with a soft and dry cloth.
②Do not use aggressive chemicals on the device such as alchol, benzene, acetone
or phenol.
③If the device is contaminated, use a mild cleaning fluid to clean.
④Make sure do not scratch the surface of equipment when cleaning it.
▶ Do not use a metal sponge.
▶If the device is rusted, remove it with a mild detergent and wipe it with a dry cloth.
• Chamber
①If the rotor chamber is not dry, wipe moisture from the chamber with a dry cloth.
②Clean the chamber, motor shaft at least once a week using a mild cleaning fluid.
• Rotor
①To prevent corrosion, take out the rotor from the rotor chamber.
②If any sample is spilt inside the rotor, wash and dry the rotor well.
▶ If you have any questions about cleaning your device, please contact us.
A/S : +82-2-3452-8966 / techsupport@ihanil.com 16
To Next Page
Loading...
