Hanna Instruments BL120 User Manual

19
INSTALLATION
6.4. CONNECTING THE PROBE TO THE PUMP CONTROLLER
Ensure the probe is connected and calibrated before installation.
1. Remove protective cap and verify the O-ring is in place. 2. Insert the nut onto the probe.
O-ring
Protective cap
Nut adapter
3. Carefully screw the adapter onto the probe taking care
not to damage the O-ring.
4. Insert the probe with the adapter and screw it carefully
into the saddle.
Screw the
adapter

Hanna Instruments BL120 Specifications

General

Brand	Hanna Instruments
Model	BL120
Category	Controller
Language	English