EasyManuals Logo

Hanna Instruments BL120 User Manual

Hanna Instruments BL120
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
INSTALLATION
6.5. INSTALLING THE ASPIRATION FILTER
The aspiration filter is used in the reagent tank to filter and prevent debris from entering the tubing.
Cut the required length of aspiration tubing (flexible) to reach between peristaltic pump inlet and aspiration filter.
The nut should be placed on the tubing before it is connected. Place the end of tubing on the filter.
The compression fitting has to be screwed in until tight on the filter.
Slide the compression fitting from the peristaltic pump inlet onto the tubing.
Slide the end of tubing over the fitting of the peristaltic pump tubing.
Slide compression fitting up over tubing.
Tighten the fitting.
6.6. INSTALLING THE INJECTOR
Cut required length of dispensing (rigid) tubing to reach between injector saddle and outlet of peristaltic pump.
Place the compression fitting nut on the tubing.
Place the end of tubing on the injector.
The compression fitting has to be screwed in until tight on the injector.
Screw the injector in the saddle.
Slide compression fitting from pump tubing onto tubing.
Slide the end of tubing over fitting of pump tubing.
Slide compression fitting over tubing.
Tighten the fitting to secure in place.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hanna Instruments BL120 and is the answer not in the manual?

Hanna Instruments BL120 Specifications

General IconGeneral
BrandHanna Instruments
ModelBL120
CategoryController
LanguageEnglish

Related product manuals