14 15
The temperature has an effect on pH. The calibration buffer solutions
are affected by temperature changes to a lesser degree than normal
solutions. During calibration the instrument will automatically calibrate
to the pH value corresponding to the measured or set temperature.
During calibration the instrument will display the pH buffer value at
25 ºC.
pp
pp
p
H BUFFER TEMPERATUREH BUFFER TEMPERATURE
H BUFFER TEMPERATUREH BUFFER TEMPERATURE
H BUFFER TEMPERATURE
DEPENDENCEDEPENDENCE
DEPENDENCEDEPENDENCE
DEPENDENCE
PMETSREFFUBHp
CºFº10.468.610.781.910.01
023 10.489.631.764.923.01
514 00.459.601.793.942.01
0105 00.429.670.733.981.01
5195 00.409.650.772.921.01
0286 00.488.630.722.960.01
5277 10.468.610.781.910.01
0368 20.458.600.741.969.9
5359 30.448.699.611.929.9
04401 40.448.689.670.988.9
54311 50.438.689.640.958.9
05221 60.438.689.610.928.9
55131 80.448.689.699.897.9
06041 90.448.689.679.877.9
56941 11.448.699.659.867.9
07851 21.458.699.639.857.9
57761 41.468.600.719.847.9
08671 61.478.610.798.847.9
58581 71.478.620.778.847.9
09491 91.488.630.758.857.9
59302 02.498.640.738.867.9
• Immerse the temperature probe in the second vessel as near as
possible to the reference thermometer. Allow a few seconds for the
probe to stabilize.
• Use the ARROW keys to set the reading on the secondary LCD to
that of the hot water.
• When the reading is stable and close to the selected calibration
point, “READY” tag will appear and “CFM” tag will blink.
• Press CFM to confirm. The instrument returns
to measurement mode.
Note: If the reading is not close to the selected
calibration point, “WRONG” tag will blink.
Change the temperature probe and restart
calibration.
To Next Page
Loading...
Need help?
General
