39
BEEP STATUSBEEP STATUS
BEEP STATUSBEEP STATUS
BEEP STATUS
Press CAL when the beep status is displayed. Beep status (“On” or
“OFF”) will start blinking.
Press the ARROW
keys to change the beep status (On or OFF).
Press CFM to save the modified beep status.
Press CAL to escape without saving.
When enable, beep sounds as a short beep every time a key is pressed or
when the calibration can be confirmed.
A long beep alert that the pressed key is not active or a wrong condition
is detected while in calibration.
CURRENT DATECURRENT DATE
CURRENT DATECURRENT DATE
CURRENT DATE
Press CAL when the current date is displayed. The year will start blinking.
Press the ARROW
keys to change the year.
Press RANGE. The month will start blinking.
Press the ARROW
keys to change the month.
Press RANGE. The day will start blinking.
Press the ARROW keys to change the day.
Press CFM to save the modified value.
Press CAL to escape without saving.
To Next Page
Loading...
Need help?
General
