Tools required for assembly (not supplied):
• A knife to cut open the box
• 10 mm spanner – to fit the emergency stop bracket
• Two 13 mm spanners - to tighten the inlet chute
• 14 mm spanner - to tighten the swivel handle
• 16 mm spanner - to unscrew and tighten the axles
• 6 mm Allen key - to tighten the wheels and the screws on the outlet chute
• 4 mm Allen key – to fit the emergency stop bracket
Box 1 contains:
✓ The chipper body
✓ Two wheels
✓ A cardboard block for support of the chipper body for wheel attachment
Box 2 contains:
✓ The inlet chute
✓ A fastener pack containing parts required for assembly
✓ The outlet chute; packed into a separate cardboard box
✓ Documentation (Hansa operations manual, warranty card and Honda motor manual)
To Next Page
