Hansa C7 - What can my Hansa chipper process?; Intended uses of the chipper; Receiving your Hansa chipper; Chipper components identification

Hansa C7eu O&M Manual - OM-019 revision B 03/09/2018
© Hansa Chippers 2018
1
What can my Hansa chipper process?
Intended uses of the chipper
The Hansa C7 chipper is built to process organic material including wooden branches not exceeding 70 mm in diameter. It is
designed for intermittent use by the suburban gardener. Do NOT use the chipper for any other purpose.
Organic wastes include:
Prunings, stalks, roots, vegetable matter, hay, grass, bark
Dry manure
Branches
Palm fronds
Dead and hard timbers (Note: these will dull the knives faster)
Paper or cardboard
Do NOT process:
Flax, root balls
Soil, bones, sand, grit, stones, metal
If you have any questions, contact your authorised dealer.
Do NOT exceed 70 mm branch diameter
Receiving your Hansa chipper
You may receive your chipper assembled from your dealer or it may be packaged in two boxes. Assembly takes approximately 30
minutes, two people working together will make the assembly easier.
Chipper components