To Next PageTo Next Page
Need help?Do you have a question about the Hansa C40 and is the answer not in the manual?
Defines the chipper's intended purpose and limitations for processing organic material.
Congratulates the owner and introduces the chipper components.
Identifies and labels key parts of the Hansa C40 chipper.
Outlines requirements for chipper operators, including age and capability.
Lists potential hazards and corresponding corrective actions for safe operation.
Explains how to adjust the direction and height of the chipper's outlet chute.
Details the operation of the feed roller using the control bar.
Explains the AFC system, its function, and adjustment procedures.
Describes the engine safety shutdown system and warning indicators.
Explains how to use the LCD display for engine RPM and machine hours.
Provides a comprehensive list of pre-operation checks for engine, hydraulics, and general condition.
Details essential steps for safely positioning and preparing the chipper before use.
Outlines crucial safety precautions for handling fuel and refuelling the chipper.
Lists essential DOs and DON'Ts for operating the chipper safely and efficiently.
Lists prohibited actions and materials to avoid during chipper operation.
Provides step-by-step instructions for starting the chipper's engine.
Details the correct steps for safely shutting down the chipper.
Addresses starting problems and common belt drive issues.
Guides on resolving issues with material feeding and discharge.
Explains how to identify when knives need sharpening and the process.
Details the steps to safely remove the chipper knives for maintenance.
Provides instructions on how to sharpen the chipper knives correctly.
Guides on the correct procedure for reinstalling sharpened or new chipper knives.
Explains how to adjust or replace the anvil for optimal cutting performance.
Explains how to check and replace drive belts and adjust tension.
Explains how to adjust the hydraulic pump belt for proper slack.
Identifies and describes lubrication points for bearings and pivots.
Details procedures for hydraulic oil filter replacement and oil changes.
Refers to the engine manual for specific servicing procedures.
Lists general servicing tasks like checking bolts and tires.
Provides instructions for replacing rotor bearings on both sides.
States the recommended tyre pressure for the chipper.
Covers general safety and inlet chute safety decals.
Identifies decals for rotor engagement and throttle controls.
Highlights decals for weekly service checks.
Shows labels related to starting, stopping, and safety procedures.
Identifies labels found on the fuel tank.
Details labels related to the hydraulic oil tank.
Shows safety labels for the feed roller motor and cover.
Highlights the safety label on the engine bonnet.
Identifies labels for oil fill level and feed control bar.
Outlines the process for registering the product and warranty requirements.
Lists conditions and damages not covered by the warranty.
Specifies limitations on HANSA's liability and product modifications.
Details the duration of registered and non-registered warranty periods.
Provides contact information for warranty and dealer inquiries.
Checks for bolt tightness, including knives, as part of initial setup.
Instructs on operating procedures, safety, and manual importance.
General
