2. Two bearings on the feed wheel
3. Two bearings on either side of the feed wheel pivot
4. Four grease nipples for pivoting the outlet chute
5. One grease nipple on the engine engagement screw (must be accessed from below the machine)
These points must be greased every 50 operating hours. Ensure a suitable grease is used (bearing grease or all-purpose grease).
Hydraulic system
Replace oil filter after first 50 hours, then every 250 hours.
The hydraulic oil should be changed every 800 hours. It is a closed system therefore it should not become contaminated, however
if contamination is detected oil should be changed. Use only a good quality brand, 32 grade hydraulic oil.
Fill the hydraulic oil tank so that the oil level is at the line indicated by the cold oil level label to the left of the oil level indicator.
The level should be checked with the engine off while the oil is cold
For any repair in the hydraulic system, contact Hansa Products or seek advice from a competent service agent.
Engine servicing
For servicing of the engine, please refer to the engine manual. Change oil, oil filter, fuel filter and air filter as recommended in the
manual. Ensure the correct engine oil is used.
Other servicing
✓ Check all bolts and other fasteners for the correct torque setting
To Next Page
Loading...
