To Next PageTo Next Page
Need help?Do you have a question about the Hansa C5 and is the answer not in the manual?
Details the intended applications for the Hansa C5 chipper.
Identifies and illustrates the main parts of the Hansa C5 chipper.
Step-by-step guide to attaching the axle to the chipper body.
Instructions for attaching the inlet chute to the chipper housing.
Ensures operators understand procedures and are qualified to use the chipper.
Identifies potential hazards and outlines corrective actions for safe operation.
Steps to ensure the chipper is safely set up and ready for use.
Guidelines for operating the chipper safely and correctly.
Step-by-step instructions for starting the chipper's engine.
Procedure for safely shutting down the chipper's engine.
Information on the type of petrol required and checking the level.
Tips for processing fibrous materials like palm fronds and leaves.
Common problems and solutions for the chipper.
Instructions and guidance on sharpening and replacing the chipper knives.
Details on how to sharpen the chipper blades using a surface grinder.
Steps for reassembling the knives after sharpening or replacement.
References to the Honda engine manual for engine maintenance.
Guidance on checking and changing the engine oil for the chipper.
How to check and adjust the belt tension on the chipper.
Step-by-step guide to adjusting the belt tension for optimal performance.
Instructions on how to replace the drive belts on the chipper.
General
