Hanseatic HWMB714A3 User Manual

Page GB-21
Care and maintenance
Cleaning the dispensing
drawer
1. Pull the dispensing drawer (1) out as far
as possible.
MAX
(33)
(32)
(1)
2. Press the marking (33) and pull the dis-
pensing drawer out completely.
3. Carefully pull the insert (32) upwards and
out.
4. Rinse the drawer and insert under run-
ning water.
5. Detergent residue in the drawer guide
and compartments is best removed with a
small dish-washing brush, bottle brush or
toothbrush.
6. Replace the insert in the dispensing draw-
er.
7. Reinsert the dispensing drawer into the
rinsing chamber.
Cleaning water inlet filter
If the water takes too long to reach the drum,
the cause may be a clogged water inlet filter.
There is a water inlet filter in both the inlet
hose and the connecting nozzle for the inlet
hose (14).
Cleaning filter in the inlet hose
1. Close the valve.
2. Switch off the appliance.
3. Unscrew the inlet hose from the valve.
(35)
(34)
4. Carefully lever the filter and gasket (35)
from the union nut (34). To do this use
e.g. a small screwdriver. Ensure you dam-
age neither the filter nor the gasket.
If the filter or gasket is damaged, replace
the defective components.
5. Rinse the filter under clean water. Use a
soft cleaning brush, if necessary.
6. Re-insert the filter and gasket, and screw
the inlet hose back onto the valve.
Cleaning filter in the inlet hose
connecting nozzle
1. Unscrew the inlet hose from the appli-
ance.
(36)
(14)
2. Use pliers to remove the filter (36) from
the inlet hose connecting nozzle (14).
3. Rinse the filter under clean water. Use a
soft cleaning brush, if necessary.
4. Re-insert the filter.
5. Firmly screw the inlet hose back onto the
connecting nozzle (14).
6. Open the valve for monitoring purposes
and inspect the hose and the connections
for leaks.

Hanseatic HWMB714A3 Specifications

General

Brand	Hanseatic
Model	HWMB714A3
Category	Washer
Language	English