Care and maintenancePage EN-24
2. Remove the dustbin (7) as
described in section “Emptying
the dustbin” on Page EN-22.
(34)
3. Remove the coarse dust fil-
ter (34) as illustrated.
4. Wash the coarse dust filter un-
der running water.
Should the coarse dust filter
be damaged or no longer suf-
ficiently cleanable, it must be
replaced with a new one.
5. Allow the coarse dust filter
to dry completely.
6. Insert the coarse dust fil-
ter back into the vacuum
cleaner.
7. Insert the dustbin as described
in section “Emptying the dust-
bin” on Page EN-22.
Cleaning the foam filter
1. Pull the mains plug (25) out of
the socket.
2. Remove the dustbin (7) as
described in section “Emptying
the dustbin” on Page EN-22.
(35)(36)
3. Remove the inlet filter (35) and
the foam filter (36).
4. Wash the foam filter under run-
ning water.
If the foam filter is damaged or
can no longer be sufficiently
cleaned, it must be replaced
with a new one.
5. Allow the foam filter to dry
completely.
6. Reinsert the foam filter into the
inlet filter.
7. Reinsert the inlet filter with the
foam filter.
8. Insert the dustbin as described
in section “Emptying the dust-
bin” on Page EN-22.
To Next Page
