Troubleshooting tablePage EN-28
Problem Possible cause Solutions, tips
Suction force
is weak.
Brush / nozzle is not
positioned correctly.
Position the brush / nozzle correctly.
Object is plugging the
nozzle.
Actuate On/Off foot switch, pull out
mains plug, check telescopic tube
and suction hose for blockage. Re-
move object.
Filters are inserted
incorrectly or are
contaminated.
Insert filters correctly and/or clean.
Air by-pass vent is
open.
Close the air by-pass vent.
Dust is being
released
from the
appliance.
Filters are inserted
incorrectly or are
contaminated.
Insert filters correctly and/or clean.
In rare cases this can make a whistling noise initially. This is not
a malfunction and stops after a while.
To Next Page
Loading...
