Operating Data Logger
USER’S MANUAL 26
10A. The default is 600mA.
2) Click “DC” key and AC will display on the screen.
3) Connect the black lead into the COM banana jack input and the red lead into the mA banana
jack input.
4) Connect the red and black leads to the measured points and the AC current value of measured
points will be displayed on the screen.
Connect Data Logger probes(HT325) with Hantek365 as illustrated in the following figure:
Figure 2-9
Then, the following figure will be displayed on the screen:
Figure 2-10 AC current Measurement for 600mA
To measure an AC current which is larger than 600mA, follow these steps:
1) Click the “A” key and then “DC” appears on the screen. The unit on the main reading screen is
mA.
2) Click the “DC” key and then “AC” appears on the screen.
3) Click “mA” key to switch to10A measurement, the unit on the main reading screen is A.
4) Insert the black lead into the COM banana jack input and the red lead into the 10A banana jack
input.
5) Connect the red and black leads to the measured points and the AC current value of the
To Next Page
Loading...