Hantek DSO 1202B User Manual

Basic Operation
DSO1000B Series HandHeld Oscilloscope User Manual 30
Operation
Source
Flash memory
USB disk
Store the current setups to the USB disk or the memory of the
oscilloscope.
Memory 0 to 9
Specify the memory location in which to store the current
waveform settings or from which to recall the waveform settings.
Operation
Save
Complete the saving operation.
Recall
Recall the oscilloscope settings stored in the location selected in
the Setup field. Push the Default Setup button to initialize the
oscilloscope to a known setup.
See below for waveform menus.
Note: The oscilloscope will save the current settings if you wait 5 seconds after the last
modification, and it will recall these settings the next time you power on the oscilloscope.
5.5.2 MEASURE
Push the MEAS button to perform auto measurements. There are 11 types of measurements and
up to 8 can be displayed at a time.
Click the MEAS key then the following menu appears.
Options
Settings
Comments
Source
CH1
CH2
Select the measure source.
Measurement
Type
Frequency Calculate the waveform frequency by measuring the first cycle.
Period
Calculate the time of the first cycle.
Mean
Calculate the arithmetic mean voltage over the entire record.
Pk-Pk
Calculate the absolute difference between the greatest and the
smallest peaks of the entire waveform.
Cyc RMS
Calculate the actual RMS measurement of the first complete
cycle of the waveform.
Min
Examine the waveform record of all points in the current
window and display the minimum value.
Max
Examine the waveform record of all points in the current
window and display the maximum value.
The white waveforms on the menu is
the recalled RefA waveform
At most 9 groups of
setups can be stored

Hantek DSO 1202B Specifications

General

Brand	Hantek
Model	DSO 1202B
Category	Test Equipment
Language	English