Hanwell IM6001 - SR2 Installation Procedure; Mounting the SR2 Receiver Unit to a Wall

Hanwell Smart Receiver 2 (SR2)
Instruction Manual
IM6001 - 3 Page 8 of 22
hanwell.com
4 Installing the SR2
There are four steps to installing an SR2:
1.
Wall-mounting the SR2. See Section 4.1.
2.
Connecting the Receiver Unit. See Section 4.2.
3.
Connecting the Power and Network connections to the SR2. See Section 4.3.
Caution:
DO NOT power up the SR2 until these steps have been completed!
4.
Configuring the SR2 in the EMS software. Refer to the Online EMS User Guide for details
on this:
http://www.help.emsprocloud.com/index.html?configuring-the-smart-receiver.html
 In addition, you can also change the Default Hardware Settings of the SR2 (see Section
5) or connect Local Sensors (see Section 5.2).
4.1 Wall-mounting the SR2
The SR2 has a keyhole and four screw holes in is rear plate. These should be used for
wall-mounting the Unit.
Note: We recommend the radio reception at the chosen location is thoroughly tested before
final wall-mounting!
1.
Use the holes in the rear of the Unit as a drilling template to mark the position of the
required screw holes.
2.
Place the SR2 on the wall and screw into place.

Figure 4 - Rear of Unit