Hanwell Smart Receiver 2 (SR2)
Instruction Manual
hanwell.com
Page 11 of 22 IM6001 - 3
Caution!
The UPS Backup Battery Float Charge has been adjusted to provide 1.5v to the battery. If the
battery is changed to another type or manufacturer, then the Float Charge MUST be changed
to suit the new battery.
Failure to do so may cause irreparable damage.
4.4 Configuring the SR2 Receiver’s Network Settings
Configuration is normally done on the network but, in some instances, it may be necessary to
connect to the Smart Receiver(s) directly.
Before the Smart Receiver(s) can be configured, fixed IP addresses should be assigned
to each unit by the Network Manager.
For information on setting up an SR2 with an IP address for use with EMS or
Synergy, please refer to Appendix 2 of this document.
You should also know the Subnet and Gateway addresses.
The Smart Receiver should be connected to the network using a straight-through
network lead (supplied).
Refer to the Section - Configuring the Smart Receiver on a Network of the EMS Online User
Guide: http://www.help.emsprocloud.com/index.html?configuring-the-smart-receiver.html for
details on how to assign an IP address to an SR2.
The SR2 is now ready to use.
Sections 5 and 6 of this Document contain optional additional settings and connections.
To Next Page